• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 30 subscribers
  • Views 230 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DRV2605: quick test sequence

Eric Steimle
Expert 2290 points
Part Number: DRV2605

Is there a quick sequence of i2c writes I could do to see if this part is functioning?  We'll get into programming for operation later.  I'm just trying to verify our new hardware.

Thank you

  • 0
    TI__Guru* 84915 points

    Hi, Eric,

    You may try with the auto-calibration instructions of datasheet: http://www.ti.com/lit/ds/symlink/drv2605.pdf#page=27

    These instructions may be used as a step-by-step guide to configure a quick auto-calibration in the DRV2605. During the auto-calibration, you will see the actuator moving, so the DRV2605 may calculate the output parameters. It may help you to verify if everything is working without digging into the whole registers programming.

    I hope this helps. Please let me know if you have additional questions or comments.

    Best regards,
    Luis Fernando Rodríguez S.