I want to run my motorsolver dyno kit by using TI microcontroller

Vishwambhar Joshi1

Other Parts Discussed in Thread: C2000WARE-MOTORCONTROL-SDK, 2MTR-DYNO, MOTORWARE

http://motorsolver.com/kits/ please follow this link I'm using this motorsolver Dyno Kit for my project so please give me direction for how can I run this kit by using TI MCU. Also please tell me which TI controller is suitable for my Dyno Kit project to run this motor.

I have TI TMDS2MTRPFCKIT so by using this kit can I run my project of Dyno Kit, If yes then tell me detail procedure or any video for that. If you have any other TI controller solution to run my motorsolver Dyno kit then please let me know.

Regards,

Vishwambhar Joshi

over 5 years ago

0 ChrisClearman over 5 years ago

TI__Guru** 119500 points

C2000Ware-MotorControl-SDK offers some examples of using low voltage LaunchPad and BoosterPack 3-ph inverters

These examples are optimized for TI's dyno set 2MTR-DYNO, but you could probably apply to your kit if you understand embedded motor control design.

You could also use MotorWare and the InstaSPIN solutions using a different LaunchPad and BoosterPack set. Here's a write-up of using them with 2MTR-DYNO:

https://www.edn.com/testing-your-motor-control-algorithms/

Motor drivers

Motor drivers forum

I want to run my motorsolver dyno kit by using TI microcontroller