• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 29 subscribers
  • Views 405 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DRV2511Q1EVM: Output line in DRV2511-Q1 EVM

YUN LIN
Intellectual 535 points
Part Number: DRV2511Q1EVM
Other Parts Discussed in Thread: DRV2511-Q1

From the Figure 8. DRV2511-Q1 Schematic 2, there are two different output line in it.

the OUTP/N and OUT, what is the difference between them.

If I want to connect a actuator to the DRV2511, I can use which one.

  • 0
    TI__Guru** 109905 points

    Hi Yun,

    OUTP/OUTN has RC filter for scope measurements.
    OUT (J7) is connected directly to the driver output.

    You should connect your external actuator to OUT - J7 connector.

    Best regards,
    -Ivan Salazar
    Applications Engineer - Low Power Audio & Actuators