48V,50A BLDC motor controller evaluation board

janardhanan siddaiyan

Other Parts Discussed in Thread: DRV8353RS-EVM

hello i am new user and starting for the electric vehicle project. i would like to know the 48V, 50A BLDC motor evaluation board availability with software and firmware for the FOC, trapezoidal controller software.

i would like to know the comonize controller and adaptable power circuit (3 phase inverter ckt)

over 4 years ago

0 Adam Sidelsky over 4 years ago

TI__Guru 63410 points

Janardhanan,

Unfortunately we do not have evaluation boards that support current this high.

Our EVMs support a maximum of 30A.

Do you have a motor selected? This would help us identify a kit for you.

Regards,

-Adam

0 janardhanan siddaiyan over 4 years ago in reply to Adam Sidelsky

Prodigy 20 points

hello Mr. Adam Sidelsky, thanks for the replay,

still not motor selected, as per my calculation am sure that i need 20A continuous to supply.

In this regard, i hope please share the details of the 30A EVM.

Basically i am looking for the controller kit and interchangeable power circuit (H-bridge for BLDC motor)

Interchangeable power circuit means --> easy to change the H bridge power circuit depends on the motor current keeping controller constant.

regards,

Janardhanan.S

0 Adam Sidelsky over 4 years ago in reply to janardhanan siddaiyan

TI__Guru 63410 points

Janardhanan,

I would recommend our DRV8353RS-EVM. This board supports up to 30A and has code available for FOC. If you need higher power then you can design your own board based on our EVM.

http://www.ti.com/tool/DRV8353RS-EVM

This board interfaces with the InsaSpin code from the C2000 team.

Regards,

-Adam

Motor drivers

Motor drivers forum

48V,50A BLDC motor controller evaluation board