DRV2510-Q1: How to unilize the DRV2510

YUN LIN

Intellectual 535 points

Part Number: DRV2510-Q1

Hi team,

Our team are going to make a software that be used to control the DRV2510 via I2C interface.

Do you have any recommendation or sample source code, thus we can program smoothly.

By the way, there are Enable, Standy, INTZ port of DRV2510.

After applying power supply to IC, what about the sequence of these ports.

Best regards,

Yun Lin

over 5 years ago

0 Luis Fernando Rodriguez S. over 5 years ago

TI__Guru* 84915 points

Hi, Yun,

I provided some answers in this e2e thread:

https://e2e.ti.com/support/motor-drivers/f/38/p/913972/3381809#3381809

Regarding the sample source code, we actually don't have examples for it since there's only one control register (0x03). You can configure it bit by bit or even write all the register options at same time. There are no restrictions or recommendations for this.

Best regards,
Luis Fernando Rodríguez S.

Motor drivers

Motor drivers forum

DRV2510-Q1: How to unilize the DRV2510