TPS50601ASPEVM-S: What is the schematic that matches this eval board, and can you provide the Gerber files too?

Neli08

I purchased the evaluation board: TPS50601ASPEVM-S. On the pcb, SLHR003 - Rev B is called out. What is the schematic that matches this eval board, and can you provide the Gerber files too? The schematic I downloaded from the help forum was SLHR003C.

Thanks,

-neli

over 4 years ago

+1 Christian Yots over 4 years ago

TI__Genius 14540 points

Hi,

The schematic and BOM are inside the published user's guide for this EVM which can be found at the following link. The gerbers are attached.

https://www.ti.com/lit/pdf/slvub65

SLHR003C_Gerbers.zip

Thanks

Christian

+1 Neli08 over 4 years ago in reply to Christian Yots

Prodigy 190 points

There was a pdf of the schematic that was revC, and I was looking at that, is there a difference?

0 Christian Yots over 4 years ago in reply to Neli08

TI__Genius 14540 points

REV C is the latest schematic. The only difference of which I am aware is that R11, termination on the SYNC pin, changed from 10kohms to 910ohms. This change was implemented during SEE testing to mitigate upsets on the SYNC pin when the internal clock (RT= populated) is being used. In the case SYNC is an output (RT=Open) or SYNC is an innput from an external source then this termination is not needed.

I will make a note to update the schematic in the UG with this change.

Thanks

Christian

Power management

Power management forum

TPS50601ASPEVM-S: What is the schematic that matches this eval board, and can you provide the Gerber files too?