TLV717P: Questions about solder paste example of X2SON(DQN) package

Kazuya Nakai59

Guru 20750 points

Part Number: TLV717P

Hello guys,

One of my customers is about to assemble their own board using TLV717P.

They have a few questions about SOLDER PASTE EXAMPLE on page 26 in TLV717P datasheet (Rev:SBVS176B).

Could you please give me your reply for the following questions?

Q1. What does the red line mean? Is it solder paste area?

Q2. I know that dotted green line means solder mask edge under solder paste. Do you have any recommended the solder overlap length with the solder mask?

Q3. Do you have any recommended gap length between center solder paste and solder mask edge?

Your reply would be much appreciated.

Best regards,

Kazuya.

over 3 years ago

0 Srikanth Lolla Venkata over 3 years ago

TI__Genius 12500 points

Hello Kazuya,

I will look into this, and get back to you by the end of the day tomorrow.

Regards,

Srikanth

0 Kazuya Nakai59 over 3 years ago in reply to Srikanth Lolla Venkata

Guru 20750 points

Hello Srikanth,

Thank you for your reply.

I'm looking forward to receiving your reply.

Thank you again and best regards,

Kazuya.

0 Srikanth Lolla Venkata over 3 years ago in reply to Kazuya Nakai59

TI__Genius 12500 points

Hello Kazuya,

The line in Red is the border of the stencil and yes, it is the solder paste area. Regarding the dimensions of the overlap and the separation of the solder mask and the central solder paste, we don't have that information in our group at this point. I have contacted the packaging group about this and I will get back to you as soon as I hear back from them. Apologies for the delay.

Regards,

Srikanth

0 Kazuya Nakai59 over 3 years ago in reply to Srikanth Lolla Venkata

Guru 20750 points

Hello Srikanth,

No problem and thank you very much for your strong supports.

I could understand the line in Red is the border of the stencil because of your reply.

Also I'm looking forward to receive your reply about the gap and overlap length.

Thank you again and best regards,

Kazuya.

0 Srikanth Lolla Venkata over 3 years ago in reply to Kazuya Nakai59

TI__Genius 12500 points

Hello Kazuya,

You could assume the dimensions of the Solder Mask from Page 25 (in green). Regarding the Edge pads, the solder mask length is 0.36mm (Page 25) and this would be the length of the overlap between the mask and the paste (along this dimension). Regarding the center pad, the length of the mask is 0.48mm (again from page 25) and the length of the paste is 0.45mm. This would result in a gap of 0.015mm between the two. Hope this was what you were looking for.

Regards,

Srikanth

0 Kazuya Nakai59 over 3 years ago in reply to Srikanth Lolla Venkata

Guru 20750 points

Hello Srikanth,

Thank you very much for the strong supports.

The information is very helpful for the customer and me.

Thank you again and best regards,

Kazuya.

Power management

Power management forum

TLV717P: Questions about solder paste example of X2SON(DQN) package