Hi team,
I want to know how to design the resonant inductance of the front section of the main circuit transformer.
Thank you very much for your help.
PS:12V 25.5W PD
Best regards,
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi team,
I want to know how to design the resonant inductance of the front section of the main circuit transformer.
Thank you very much for your help.
PS:12V 25.5W PD
Best regards,
Hi,
If customer is looking for a high efficiency 12V/25.5W PoE design, I recommend looking at TPS23754EVM-383.
This is an active clamp forward design that is optimized for high efficiency at 92-93% for the DC-DC.
Best Regards,
Brett Colteaux
Hi Brett,
Thank you for your reply.
When the load is 1.8A, the driving waveform of primary MOS transistor is as follows.
What are the reasons? Output 12V, design power 25.5w
The schematic diagram is designed with reference to demo board 383.
Please help me analyze it.
Thanks again.
Best regards,
Hello,
Are you able to share a schematic?
The following paper is a deep dive into designing an active clamp forward, but typically it is easier to use a known working design and compare the differences to the board experiencing issues:
If this post answers your question, please indicate so by marking this thread as resolved. Thank you.
Regards,
Michael P.
Applications Engineer
Texas Instruments
Hello,
Is there any update on this case?
If this post answers your question, please indicate so by marking this thread as resolved. Thank you.
Regards,
Michael P.
Applications Engineer
Texas Instruments
Hello,
I have not heard from you in a few days. Do you have any update on this post? I want to make sure you are setup for success for your project, but if I do not hear from you I will close this thread. Feel free to post here or on a new E2E post to continue the conversation. Thank you
If this post answers your question, please indicate so by marking this thread as resolved. Thank you.
Regards,
Michael P.
Applications Engineer
Texas Instruments