TL1451A: Question about SCP

NOBUO FUJIHARA

Expert 8615 points

Part Number: TL1451A
Other Parts Discussed in Thread: LM5157

Hi team,

Could you support question from the customer below?

Q1) Could you provide VCC lower limit which SCP is functional?

Is it correct to think SCP operates until VCC goes down until UVLO, which is shown in Fig.11?

Q2) Could you provide period of time from "VCC =3.6V" to "internal Vref gets stable"?

best regards,

over 3 years ago

0 Richard Fu22 over 3 years ago

TI__Mastermind 23390 points

Hi Fujihara-san,

The person responsible for this device is out of office due to holiday and will be back by end of next week. They may need some additional time to support.

Thanks,

Richard

+1 dehuan Qi over 3 years ago in reply to Richard Fu22

TI__Intellectual 2775 points

Hi Fujihara-san,

Thank you for your patience. This is a very old device, I spent some time searching for information, so I spent more time check this question.

1）Yes， It is true until VCC hit UV.

2）There are negligible delays from Vin to VCC output because is an LDO, and the VCC output should follow VIN with negligible delays.

This device is very old, in the new design, we suggest some new devices, so that the support will be more adequate. for this case ，you can ref the LM5157.

The DS link as below：

www.ti.com.cn/cn/lit/ds/symlink/lm5157.pdf

BR Dehuan

0 NOBUO FUJIHARA over 3 years ago in reply to dehuan Qi

TI__Expert 8615 points

Hi Dehuan-san,

Thanks a lot for your dedicated support.

best regards,

Power management

Power management forum

TL1451A: Question about SCP