TPSM82813: Top marking is blanking

Hi Cera,

With these uSiP power modules, there is sometimes not enough space to write the markings on the top of the device.  Since these came from the TI Store, I would assume they are perfectly fine and ok to use.

I will reply back in the next few days with the location of the GD marking.  It may be on the back of the device or under the inductor.

Thanks,

Chris

Hi Chris,

Thanks for checking it. While my customer checked it, there's no mark on any side of the device. Customer needs the mark to make sure they are using the right device. The chip is samples applied from TI store. 

webwxgetmsgimg (5).jfifwebwxgetmsgimg (6).jfifwebwxgetmsgimg (4).jfifwebwxgetmsgimg (3).jfif

Regards,

Cera

Thanks for sending the images.  Can you send a zoomed in one of the back of the device?

The marking should be located between pins 5 and 6, as shown below:

Chris