Hi,
Where can I found FUSION SW that support UDC90124?
Thanks,
Erez
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi Yihie,
I couldn't guess from TI WEB that it's not supported (The device status is active).
I think you should consider change the status to Not recommended to new design.
(I have purchased 50 devices that I have to throw away)
Thanks,
Erez
Hi
Here is the very old GUI to support UCD90120.
but the support of the UCD90124 is very limited and we strongly recommend to move to the A version.
TI-Fusion-Digital-Power-Designer-2.0.179.zip
Regards
Yihe