BQ34Z100-G1: Learning Cycle tab in BQstudio

Deepak Singh

Prodigy 65 points

Part Number: BQ34Z100-G1
Other Parts Discussed in Thread: BQSTUDIO, BQ34Z100

HI,

why there is no learning cycle tab in the BQstudio incase of other GAUGE ICs it shows something like this:

does this mean there is a diffrence between calibration process in diffrent gauges?

or something wrong with BQstudio?

or something else?

over 3 years ago

+1 Shirish over 3 years ago

TI__Guru 57697 points

Hello Deepak,

Learning cycle is typically available in single cell gauges. For multiple cells, there are a lot of dependencies and assumptions.This is probably one of the reasons why it is not available for bq34z100. While the gauges share similar features, each is very different in features and capabilities. Hope this helps.

0 Deepak Singh over 3 years ago in reply to Shirish

Prodigy 65 points

Ok got your point but process is same i think for learning cycle we have to follow the same steps

+1 Shirish over 3 years ago in reply to Deepak Singh

TI__Guru 57697 points

Yes, the learning process follows the same steps.

Power management

Power management forum

BQ34Z100-G1: Learning Cycle tab in BQstudio