Other Parts Discussed in Thread: LMR14020, LMR14020SS-Q1
Hi,
I am quite new the the TI tool here. I was able to use and run simulation on WEBENCH POWER DESIGNER for LMR14020 parts yesterday.
Somehow I am not able to run the simulation today, and it says the device is not WEBENCH enabled even though I was able to use yesterday.
Could you tell me why I am seeing this error message? My design requirement remained the same as I used yesterday.. (40Vin to 24Vout, 2A).
Thanks
**Edited : it's just not this particular part, I am not able to load any simulations by using any parts. Is there something wrong on the server?