PTN04050C: PTN04050CAD 3D model in Ultra Librarian is for surface mount even though it state EUU4.step

Manie Coetzer

Prodigy 110 points

Part Number: PTN04050C

The 3D model for the through hole part PTN04050CAD still shows the surface mount model.

over 3 years ago

0 Brigitte over 3 years ago

TI__Guru 67755 points

Hello Manie,

Please excuse the late response. I need to check the model in detail and then request an update, if needed. please give me at least a week for getting back to you.

Best regards,
Brigitte

+1 Brigitte over 3 years ago in reply to Brigitte

TI__Guru 67755 points

Hello Manie,

You are right, the drawing on the Ultra Librarian page for the through hole device is not correct. I will take care to get it updated.

At the moment we are checking if this is just a problem with the website or if the footprint that you would receive via a download needs to be updated as well.

Best regards,
Brigitte

0 Brigitte over 3 years ago in reply to Brigitte

TI__Guru 67755 points

Hello Manie,

We are in the process of updating the footprint, but this will take some time. So I will close the thread now as this will be finalized outside E2E. Please let me know, if you need in the meantime an intermediate footprint.

Best regards,
Brigitte

0 Manie Coetzer over 3 years ago in reply to Brigitte

Prodigy 110 points

Thank you for looking into this and updating the footprint.

Best regards,

Manie

Power management

Power management forum

PTN04050C: PTN04050CAD 3D model in Ultra Librarian is for surface mount even though it state EUU4.step