UCD90320U: Programming UCD90320 instead of UCD90320U

Mike Hsu

Part Number: UCD90320U
Other Parts Discussed in Thread: UCD90320,

Hi there

I have two image files (.XML and .tisfp) was built based UCD90320U. However the we want to program to UCD9032. It seems the image files can not be programmed to UCD90320.

How do I convert the image files to UCD90320 compatible in Fusion Design Tool, so that UCD90320 can be programmed?

Thanks

Mike Hsu

over 3 years ago

0 yihe over 3 years ago

TI__Guru 66700 points

There are some features differences between non-U and U part. so the project file may not be fully compatible.

You can try to modify the XML to replace the UCD90320U with UCD90320, including the DEVICE_ID.

The device_id is the return from 0xFB command(DEVICE_ID). Do you have the UCD90320 device?

But after these, some fine tuning is still need on the LGPO configurations.

Do you have xml file?

Regards

Yihe

0 Mike Hsu over 3 years ago in reply to yihe

Intellectual 300 points

Yes, I have .XML file and I have UCD90320 device

Tell me how to modify the XML to replace the UCD90320U with UCD90320,

+1 yihe over 3 years ago in reply to Mike Hsu

TI__Guru 66700 points

Could you provide both files? it does not seem that the file was modified properly

Regards

Yihe

Power management

Power management forum

UCD90320U: Programming UCD90320 instead of UCD90320U