PSPICE-FOR-TI: After installing PSpice-For-TI, OrCAD stopped working.

Shuji Ishiwata

Mastermind 7940 points

Part Number: PSPICE-FOR-TI

Hi All,

I have a question about PSpice-For-TI.

I installed PSpice-For-TI, but I can't launch the installed OrCAD.
Have there been any reports of such phenomena?

Best Regards,
Ishiwata

over 3 years ago

0 Jackie Horn over 3 years ago

TI__Expert 5880 points

Hi Ishiwata,

PSpice for TI and Orcad should not conflict. Please try closing any PSpice for TI windows before launching Orcad. Which version of Orcad are you running?

Thank you,

Jackie

0 Shuji Ishiwata over 3 years ago in reply to Jackie Horn

Mastermind 7940 points

Hi Jackie,

Sorry for the late reply.
I was checking the customer's OrCAD version.
OrCAD version 16.6-S003

When trying to start OrCAD after installing PSpice-For-TI
I couldn't start it with the message that 4 DLLs were not found.

Best Regards,
Ishiwata

0 Jackie Horn over 3 years ago in reply to Shuji Ishiwata

TI__Expert 5880 points

Hi Shuji,

Can you please share a screenshot of the error message?

Thank you,

Jackie

0 Shuji Ishiwata over 3 years ago in reply to Jackie Horn

Mastermind 7940 points

Hi Jackie,

I received a reply that it started normally from the customer side.
Thank you for your support.

Best Regards,
Ishiwata

0 Jackie Horn over 3 years ago in reply to Shuji Ishiwata

TI__Expert 5880 points

Hi Ishiwata,

Thank you for the update!

-Jackie

Power management

Power management forum

PSPICE-FOR-TI: After installing PSpice-For-TI, OrCAD stopped working.