Hi there
According to TI UCD90xxx Sequencer Schematics Guidelines (Rev. C). Unused GPIO pin should connect to GND right?
What would happen if unused GPIO pins left as floating (no connection)
Thanks
Mike Hsu
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi there
According to TI UCD90xxx Sequencer Schematics Guidelines (Rev. C). Unused GPIO pin should connect to GND right?
What would happen if unused GPIO pins left as floating (no connection)
Thanks
Mike Hsu
Hi there
TI Mr. Yihe did not find unsued GPIO should connect to GND
Can you review the A1 & A2 schematic thoroughly again.
Thank you
Mike Hsu