UCC27537: schematic and MOS check

Fred Cheng

Expert 5230 points

Part Number: UCC27537

Hi team,

my customer use this on EV charging relay switch.

would you help check if this MOSFET is the right fit?

and check if the schematic has anything wrong?

over 1 year ago

0 Aiyappa Byrajanda over 1 year ago

TI__Prodigy 10 points

Hi Fred,

One of our expert engineers has been assigned to this thread. You should hear back from them soon. Response might be delayed through Jan 3 because of the Holiday season. Thank you for your patience.

Aiyappa

0 Fred Cheng over 1 year ago in reply to Aiyappa Byrajanda

TI__Expert 5230 points

Hi Aiyappa,

I wish it can be sooner, but understand.

I'll wait for the review

Regards,

Fred

0 Daniel Norwood over 1 year ago in reply to Fred Cheng

TI__Expert 5831 points

Fred,

Thanks for your patience. I will check if any of our experts on this device will be in office sooner to review this.

One thing I can say is that it is really hard for us to give useful feedback on the MOSFET selection, as the selection is very dependant on the whole system.

We will get back to you when our expert is available.

Regards,

Daniel

0 Ethan Galloway over 1 year ago in reply to Fred Cheng

TI__Mastermind 19280 points

Hi Fred,

I am filling in for our expert in gate drivers.

Your schematic looks good. Your MOSFET also looks good. I can't see the values on your resistors, but make sure the enable pin stays above 2.1 volts.

In your layout, make sure to have the driver and the FET as close together as possible. Make sure to minimize the length of high current traces.

Best Regards,
Ethan Galloway

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Power management

Power management forum

UCC27537: schematic and MOS check