This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

BQ40Z80: Putting BQ40Z80 in read-only mode after configuration

Part Number: BQ40Z80

Hello,

I have a battery in my device that is managed by a BQ40Z80. After initial configurations, I would like to put all device registers in a read only mode. Is this a possibility on this chip? I am aware of SEALED mode, which removes access from the Manufacturer Access Block, but I would like to be able to "seal" all registers.

Best,

Jacob O'Donnell