TPS7A91: TPS7A9101DSK

Hello Govind,

These are my comments after reviewing TPS7A91 schematic:

- It is required to have a 10kΩ to 100kΩ pull-up resistor connected to PG pin.

-Make sure that the time constant of both the LDO startup and the power-good output are matching, which can be done by adding a capacitor in parallel with the power good pullup resistor. For more information, see the Pros and Cons of Using a Feedforward Capacitor with a Low Dropout Regulator.

- Just to make sure that the desired soft-start ramp time is 0.8ms which is calculated using below equation:

Best,

Eunize Tobias