TUSB1064RNQEVM: Original project files for the EVM

YUSUKE ONISHI

Part Number: TUSB1064RNQEVM
Other Parts Discussed in Thread: TUSB564, TUSB1046EVM

I'd like to get TUSB1064RNQEVM's original project files for the EVM.

This issue was discussed at this thread https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1203149/tusb1146evm-original-project-files-for-the-evm,
but below link seems to be broken.

>TUSB546/1046 EVMs share the same PD controller firmware, same for TUSB564/1064. Please see link below:
>https://txn.box.com/s/l4i4tp9f67dg9ylcqt3ykkjqn5djlc5n
>Regards,
>Undrea

Does someone fixed this link?

Thanks

over 1 year ago

0 Brian Zhou over 1 year ago

TI__Guru** 122810 points

pls accept my friendship request.

Regards

Brian

+1 Brian Zhou over 1 year ago in reply to Brian Zhou

TI__Guru** 122810 points

sent

0 YUSUKE ONISHI over 1 year ago in reply to Brian Zhou

Prodigy 35 points

Dear Brian-san,
When using as GPIO mode, DisplayPort alt function doesn't work at both 2 lane and 4 lane mode.
I use default firmware(no-changed) , and changed JMP7 as pin1-2 short (GND).
Could you give some advice for this problem?

My environment:
- Displayport 2 lane : Full HD monitor
- Displayport 4 lane : 4K 144Hz (ASUS : PG43UQ 43)

Thanks

0 Brian Zhou over 1 year ago in reply to YUSUKE ONISHI

TI__Guru** 122810 points

What is your setup?, you connecte TUSBEVM to typec host or to TUSB1046EVM?

Best

Brian

0 YUSUKE ONISHI over 1 year ago in reply to Brian Zhou

Prodigy 35 points

I use TUSB1064RNQEVM.
PC(USB TypeC) -> Usb cable -> TUSB1064RNQEVM (default firmware) -> display port cable -> PC monitor

I confirmed that it works without problem when using I2C mode(default jumper setting) for both 2/4 lane monitor.
But when I change the JMP7 (I2C enalbe) to GND for changing GPIO mode, it doesn't work.

Thanks.

+1 YUSUKE ONISHI over 1 year ago in reply to YUSUKE ONISHI

Prodigy 35 points

Sorry, I found the solution.

When using GPIO mode, I changed below 4 jumpers and it works.
Important thing is "don't pull JMP7's default jumper: 4-5" and just add jumper at 1-2.

GPIO mode :
-J1 : FLIP = VCC (depends on connector's front and back)
-J2 : CTL0 = 2 lane -> both VCC and GND is ok
-J3 : CTL1 = VCC
-JMP7 : I2CEN = GND (connection : 1-2 + default :4-5 )

JMP7
6NC , 3 VCC
5R ,2 I2C_EN
4NC ,1 GND

Power management

Power management forum

TUSB1064RNQEVM: Original project files for the EVM