I am try to run a simulation in TINA with the LM60440A-Q1 - TRANS.lib (see schematics below)
and it fails to run.
Any suggestions?
Sincerely,
Giora
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
I am try to run a simulation in TINA with the LM60440A-Q1 - TRANS.lib (see schematics below)
and it fails to run.
Any suggestions?
Sincerely,
Giora
Hi Giora,
It is important to use the correct model that is currently supported on the product folder.
If you download the PSpice transient model that I referred to, the folder files would look like below. In it, you will see a opj file that you can open to start simulation for this device.
Regards,
Jimmy
Hello Giora,
Because I don't have much experience on TINA, I can only comment on PSPICE.
If it is working on ORCAD, please continue using your files using that software.
If you have any specific question on the TI released software on the LM60440-Q1 product folder, please let me know so I can further assist.
Regards,
Jimmy