TPSF12C1-Q1: SPICE component

Thank you Timothy,

I will try to get PSPICE. I have used the quickstrat calculator. I have made changes for my design but i would like to see the time domain waveforms using some simulations.

Hello Timothy

You mentioned SIMPLIS for the simulation. But with the SIMPLIS I am getting errors while simulation. How can I obtain an un-encrypted model of TPSF12C1?.

Thank you Tim,

I was able to simulate using PSPICE.

I would like to know how the AEF loop gain is computed. With some changes made in the design sheet, I have obtained a particular loop gain curve. I would like to simulate the same in PSPICE and verify it. How should I approach the ac analysis?

Regards

Nakul

Hello Tim,

The excel tool says to use Rg within 1k and 2k. What happens if i use say 10k for the gain? What criteria need to be followed while selecting the gain settings?

Hello Tim,

Thank you for the model.

Could you tell me which points are the gain loop measured from?

Also the model has a STAB pin. What does this pin corresponds to?

If I have to measure the loop gain using a bode analyser and the hardware on bench, where should I connect the terminals of the bode analyser? I am trying to achieve the same characteristics with the configuration TI has provided using the hardware and then use our filter design to  achieve a suitable characteristics.

Regards

Nakul

Thank you Tim.