LMR36015FSCEVM: why there is a bump in the transition when doing a dynamic experiment？

Mark-Lee

Part Number: LMR36015FSCEVM

Hi, TI expert.

I used LMR36015FSCEVM to do a dynamic experiment, there is a bump in the transition when the output current decreases. What is the reason for this? as the green waveform show in below figure.

over 2 years ago

Hongjia-Wu over 2 years ago

TI__Expert 6680 points

Hi,

Can you check what' going on with your load? The load current is applied externally to the DCDC and the DCDC itself usually cannot make the change.

Regards,

Hongjia

Hongjia-Wu over 2 years ago

TI__Expert 6680 points

Hi Mark,

As there is no reply for quite a few days, I would close the thread. You can reopen the thread or create a new one if you have any further update.

Regards,

Hongjia

Power management

Power management forum

LMR36015FSCEVM: why there is a bump in the transition when doing a dynamic experiment？