BQ34Z100: Value is beyond maximum value defined for parameter.Calibration,Data.CC Delta

Hi Star,

Is the sense resistor configured properly?

Regards,

Evan

Hi Evan 

Thanks for your reply.

The sense resister setting is 0/0/1（Disabled）

How to configure this resistor? What is the basis for configuration?

Thanks

Star

Hey Star,

Today's a federal holiday so no one is in the office. We will get back to you tomorrow.

Regards,
Nick Richards

Hi Star,

The sense resistor used in the design needs to configure properly on the gauge.

The error you are receiving is usually due to an error here.

6.2 +table , 3.3.1 - BQ34Z100-R2 Technical Reference Manual (Rev. A) (ti.com)

Regards,

Evan

Hi Evan

Thanks for your reply.

CC Delta auto update when calibration. 

CC Delta default is 10 mohm. When calibrated it to 1.1 mohm or 2.14 mohm said it was out of range.

How to solve this issue?

Thanks

Star

Hi Star,

Have you changed sense resistor configurations?

Regards,

Evan