• State TI Thinks Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 63 subscribers
  • Views 277 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS25730: tell me your recommended products(USB-PD control and charger ICs)

moe
Prodigy 10 points
Part Number: TPS25730

Tool/software:

In addition to TPS25730, if you have any recommended USB-PD control and charger ICs, please contact us.
Could you introduce me?
*For USB-PD, I would like a sink-only device that supports 240W (USB3.1).
If that isn't available, USB3.0 (100W) would be fine.

  • 0
    TI__Mastermind 30000 points

    Hello,

    For 100W sink only, the TPS25730 would be the best device to use. This is a resistor configurable PD controller allowing you 100W power negotiation without any firmware development required. 

    For 240W, we have a new device that will release later this year to be able to negotiate the new 240W power range. 

  • 0 in reply to Adam Mc Gaffin
    Prodigy 10 points

    Thank you for your answer!


    Can you tell me one more thing?

    If you use TPS25730,
    Which charger IC do you recommend?
    (Sorry, I'm not an engineer and have no expertise.)
    There are too many to choose from, so could you give me some suggestions?

  • 0 in reply to moe
    TI__Mastermind 30000 points

    Hello,

    This depends on your system requirements. Would you be able to share some information about your battery system?

    i.e. what is the battery pack chemistry, how many battery cells do you plan to support, do you need to both charge the battery and power the system at the same time