BQ21080: Configuration storage

João Rego

Part Number: BQ21080

Tool/software:

Hello,

If the power is removed (neither VIN nor VBAT), will the BQ21080 store the user configurations? Or will it revert to the default settings?

Also, which are the default settings?

Thank you.

Best regards,

João Rego

over 1 year ago

0 Alec Lehman over 1 year ago

TI__Genius 13105 points

Hello João,

Yes, the registers will reset to their default settings if the device is not being powered by VIN or VBAT or if an event occurs that causes a power-on reset (POR).

Please refer to section 8.5 "Register Maps" of the BQ21080 datasheet. For example, see the IC_CTRL register below:

The default/POR value of this register is 0x84 (84h). Additionally, the default values of each bit can be seen in the table. For example, bit 7 (the TS_EN bit) is "1" (1b1) by default.

Best regards,

Alec Lehman

0 João Rego over 1 year ago in reply to Alec Lehman

Intellectual 326 points

Hello Alec,

Thank you for your answer.

I think I understood but just to be sure: if the device didn't have VIN or VBAT, the registers will reset to their default state. So, if we keep the VBAT (without VIN), the registers will be saved and vice-versa (with VIN and without VBAT).

Best regards,

João Rego

0 Alec Lehman over 1 year ago in reply to João Rego

TI__Genius 13105 points

Hello João,

Yes, both of those statements are correct.

Additionally, it is important to note that the registers can be reset in several ways. For example:

The device entering shutdown mode
The watchdog timer expiring
VBAT falling below BUVLO

Best regards,

Alec Lehman

0 João Rego over 1 year ago in reply to Alec Lehman

Intellectual 326 points

Hello Alec,

That's clear to me. Thanks.

Best regards,

João Rego

0 Alec Lehman over 1 year ago in reply to João Rego

TI__Genius 13105 points

Hello João,

No problem. Please don't hesitate to reach out anytime.

Best regards,

Alec Lehman

Power management

Power management forum

BQ21080: Configuration storage