Tool/software:
DEAR SIR,
I AM USING GATE RESISTNACE AT IGBT MODULE WITH GATE PCB AND I AM SORTING PIN OUTH , OUTL WITH CLAMP BEFORE GATE RESISTANCE IT IS OK PLEASE REPLY ENCLOSED SCHAMTIC Driver-Vertical-VP006848-UCC21750_R001.pdf
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Tool/software:
DEAR SIR,
I AM USING GATE RESISTNACE AT IGBT MODULE WITH GATE PCB AND I AM SORTING PIN OUTH , OUTL WITH CLAMP BEFORE GATE RESISTANCE IT IS OK PLEASE REPLY ENCLOSED SCHAMTIC Driver-Vertical-VP006848-UCC21750_R001.pdf
8750.Driver-Vertical-VP006848-UCC21750_R001.pdf
PLEASE CHECK THIS PDF FOR DRIVER HERE NOT USE CLAMP PIN IN SAME SCHMATIC CAN SORT CLMAP PIN WITH OUTH & OUTL ??
Hi Upender,
There is an internal FET between CLAMPI and VEE. If you short them together, this FET will have no effect. However, this pin is designed to improve the Miller injection immunity of the circuit, and I recommend that you attache CLAMPI to OUTL, not VEE.
Best regards,
Sean
It is recommended to connect CLMPI to GATE (least resistive path to pull down the gate effectively to Low) when INP=L to overcome the miller injection behavior.
Thanks
Sasi
Dear sir ,
Can short OUTH , OUTL & CLAMP PIN SHORT before gate resistance because we use Gate pcb directly IGBT module ,
Hi Upender,
Yes, this second circuit will have better Miller injection immunity than the first circuit.
Best regards,
Sean