TPS62874-Q1: How to simulate buck in stacked configuration.

Sayali Jadhav

Part Number: TPS62874-Q1

Tool/software:

Hello,

I wanted to simulate four TPS62874-Q1 bucks in stacked configuration in WEBENCH power designer. but not getting any option to do in WEBENCH.

So, wanted to know how to simulate bucks in stacked configuration?

Regards,

Sayali Jadhav

0 Tanvee 5 months ago

Hi Sayali,

Simulation models for stack configuration is available on SIMPLIS and PSPICE simulator. Unfortunately, Webench model can not support it.

You can use either of simulator to run the circuit. let me know if you have trouble to se the bench test.

Best regards,

Tanvee

0 Sayali Jadhav 5 months ago in reply to Tanvee

Hi Tanvee,

Thanks for the response.

Can you tell me which tools are required to simulate this PSPICE, SIMPLIS model and how I can use them?

Regards

Sayali

0 Tanvee 5 months ago in reply to Sayali Jadhav

Hi Sayali,

For PSPICE model, you can use the PSPICE-FOR-TI Simulation tool | TI.com and you can get more information on SIMetrix Circuit Design and Simulation for SIMPLIS tool.

Test bench for model. you can use it directly.

Best regards,

Tanvee

Power management forum