BQ34Z100-R2: the dsg bit is toggling even after the discharge is completed and does not stops.

Ankit Ahlawat

Prodigy 110 points

Part Number: BQ34Z100-R2
Other Parts Discussed in Thread: BQSTUDIO

Tool/software:

Hi ,

After Discharging the battery to the empty. The DSG bit keeps on toggling to 1 and 0.What could be the issue?

I left it more than the 5hr still the same issue.

Pls give me the solution

Thanks.

5 months ago

0 Alan Frias 5 months ago

TI__Mastermind 26495 points

Hello Ankit,

That would make sense since once the battery reaches it "empty state" or what you set your termination voltage too than the discharge FET would open to prevent from going below its empty/termination state. If order to prevent this you would need to review your BQStudio >> Data memory, parameters and specially DSG current Threshold, OT Dsg, Cell Terminate Voltage and etc.

Thank you,
Alan

0 Ankit Ahlawat 5 months ago

Prodigy 110 points

Hi Alan,

I will review the data memory and update if there is any discrepancy.

Thank you.

0 Alan Frias 5 months ago in reply to Ankit Ahlawat

TI__Mastermind 26495 points

Hello Ankit,

Sounds good.

Thank you,
Alan

Power management

Power management forum

BQ34Z100-R2: the dsg bit is toggling even after the discharge is completed and does not stops.