TPSF12C1: How to use this device

R.Fukunaga

Expert 2435 points

Part Number: TPSF12C1

Tool/software:

Hi all,

I have two questions about how to use the TPSF12C1.

1) The recommended circuit always uses 2CM coils, Is it needed 2coils?

2) This IC is listed as compatible with IEC61000-4-5. Why is it compatible? Please provide more details.

Please let me know if you have an application note with details.

Best Regards,

Ryusuke

0 R.Fukunaga 3 months ago

Expert 2435 points

Hi all,

How is your progress?

I would appreciate any comments.

Best Regards,

Ryusuke

0 Naresh Adepu 3 months ago in reply to R.Fukunaga

Hello

I will get back on this.

Thanks and regards,

+1 Naresh Adepu 3 months ago in reply to Naresh Adepu

Hello Fukunaga,

Yes, the architecture is based for a two-stage filter. two CM choke coils are needed.

Yes, the device has inherent protection features for robust design – Withstands surge of 6 kV (IEC 61000-4-5) with minimal external component count. Please refer to datasheet page 19 and 20 for more details. TPSF12C1 Standalone, Active, EMI Filter for Common-mode Noise Mitigation in Single-Phase, AC, Power Systems datasheet (Rev. A)

Also, the following application note can help you with more information on the architecture - How Active EMI Power-Supply Filter ICs Mitigate Common-Mode Emissions

thanks and regards,

naresh

0 Naresh Adepu 3 months ago in reply to Naresh Adepu

Hello Fukunaga,

Yes, the architecture is based for a two-stage filter. two CM choke coils are needed.

Also, the following application note can help you with more information on the architecture - How Active EMI Power-Supply Filter ICs Mitigate Common-Mode Emissions

thanks and regards,

naresh

Power management forum