BQ79616-Q1: Inquiry about OTP Programming Steps for BQ79616-Q1

Tom Tsao

Expert 1960 points

Part Number: BQ79616-Q1

Tool/software:

Hi TI Team,

I have a question regarding the OTP programming process for the BQ79616-Q1. Could you please provide the detailed steps or procedure for programming the OTP memory on this device?

Specifically, I would like to know:

What are the required commands or sequence to initiate OTP programming on the BQ79616-Q1?
Are there any specific configuration requirements or considerations before programming OTP?
Is there any related documentation or application notes that provide additional details or best practices for OTP programming?

Thank you for your assistance. I look forward to your response.

Best regards,

Tom

6 months ago

0 Zachary Balov 6 months ago

TI__Expert 4840 points

Hi Tom,

I'll get back to you by the end of the week.

Thanks,

Zachary

0 Tom Tsao 6 months ago in reply to Zachary Balov

Expert 1960 points

Hi Zachary,

Hope you’re doing well. Just wanted to kindly follow up and check if there are any updates on your side?

Thanks!

Best regards,
Tom

0 Zachary Balov 6 months ago in reply to Tom Tsao

TI__Expert 4840 points

Hi Tom,

Sorry for the delay. We dont have any documentation to provide on best practices. There aren't any specific requirements which need to be met as long as the hardware design of the board is correct. If you refer to page 61 on the datasheet, you will see the steps required to initiate OTP programming. If you have any specific questions on specific registers or settings with your programming, please feel free to start another thread.

Thanks,

Zachary

Power management

Power management forum

BQ79616-Q1: Inquiry about OTP Programming Steps for BQ79616-Q1