PFCLLCSREVM034: Gerbers

Is there a contact email or link for that?  I thought these forums were to correct venue for technical support, that's all.  Thanks.

The schematic is available online in the PDF file. You can build the design from it.

The source file is not available online. Since we don't share our email here through this forum, in order to send you the file, it is recommend you to go through our FAEs first. Or you can leave your email address here.

My email is jfledderman@ergpower.com.  I have the schematic.  I'm much less concerned about the calculations and circuit design then I am about the actual layout of the board.  The user manual's images on the board layout are somewhat blurry, so it's just difficult to see what component is where - gerbers would just make it easier to look at.  If an FAE is able to email me the files, I'd much appreciate it.  Thanks.

Joe,

OK, we will email you the gerber file.

I will close this thread.

Best

Ning,

Thanks, that will help.  No one had sent me any gerbers in the past day.  I'm not in any super rush, but didn't want the request to fall through the cracks.  Any idea how long it takes for FAEs to get to these requests?

Thanks,
Joe

Sorry for the wait. I sent you the file. Please check.

Best,

Ning