EV2400: FW programming process

Kailun Liu

Part Number: EV2400

Tool/software:

Hi Team,

My EV2400 MCU is broken so I replace a new MSP430 in PCB. May I know how to programming EV2400 FW into a branding new MSP430?

Below is the tool I download from ti.com but it shows no connect, it seems that this tool focus on FW upgrading instead of programming into new device?

1 month ago

0 Alan Frias 1 month ago

TI__Mastermind 26045 points

Hello Kailun,

This question has been assigned and will be reviewed when possible.

Thank you,
Alan

0 Kailun Liu 1 month ago in reply to Alan Frias

TI__Expert 3063 points

Hi Alan,

May I have your professional feedback? THanks!

0 Kailun Liu 1 month ago in reply to Alan Frias

TI__Expert 3063 points

Hi Alan,

What happened in BGP team? It has been 7days without any reply.

+1 Anthony 1 month ago in reply to Kailun Liu

TI__Mastermind 28470 points

Hi Kailun,

Just to confirm, have you tried running the command with the -s flag attached?

If you have, you might need to run attach a jumper to the JP header (it is a white 2 pin header on the physical board), and unplug the device and plug it back in to put it in bootloader mode. I believe this should allow you to reprogram.

Please let me know if this works.

Regards,

Anthony

0 Kailun Liu 1 month ago in reply to Anthony

TI__Expert 3063 points

Hi Anthony,

Thanks for your professional support!

0 Kailun Liu 1 month ago in reply to Anthony

TI__Expert 3063 points

Hi Anthony,

May I know what tool and file customer need after connecting JP7?

Power management

Power management forum

EV2400: FW programming process