Tool/software:
What are the setting needed to be updated to the EVM to charge a 0.1F cap (ELECTROLYTE ) from 0V to 28V ?
Tool/software:
What are the setting needed to be updated to the EVM to charge a 0.1F cap (ELECTROLYTE ) from 0V to 28V ?
Hi,
You should change the FB resistor network or adjust the register (or a combination of both). The default configuration is 29.4 V.
Set EN_TERM = 0. This will stop the charge/recharge oscillation.
Set EN_PRECHG = 0. This will allow for full charge current at low capacitor voltages.
Adjust the input/output current limits to the system specifications.
Adjust the input ACUV/ACOV to the system specifications.
Let me know if this works.
Best regards,
Michael
Set EN_PRECHG = 0. This will allow for full charge current at low capacitor voltages.
this will support from 0V right no need external power source to change to a predefined voltage is that correct ?