Not able to simulate LM25118 using webench tool.

Dibin Mathew

Other Parts Discussed in Thread: LM25118, LM5118, TINA-TI

Hi,

I want to simulate LM25118 design using webench. But, I cudn’t see the option to “Run simulation” in the window that displayed in the webench tool.

Pls let me know whether is it possible to do simulation for LM25118.

Thanks and Regards

Dibin Mathew

over 13 years ago

0 Akshay Mehta over 13 years ago

TI__Genius 15810 points

Hello Dibin,
We encountered some anomalies with the simulation model for the LM5118/25118 devices. Therefore we have disabled the feature for these devices until we figure out the solution. I apologize for the inconvenience caused to you.

Regards,
Akshay

0 Ghassan Adhami over 12 years ago

Prodigy 10 points

Hello TI, any updates on simulating LM25118?

Thanks

0 Nitin Sonar over 11 years ago in reply to Ghassan Adhami

Prodigy 30 points

Hi,

Even i am facing same problem of unable to simulate LM25118 regulator. I need to do this before i go in to PCB revision due this month end. Can some one help?

Best Regards

Nitin Sonar

0 Kevin Ip over 11 years ago in reply to Nitin Sonar

TI__Intellectual 2155 points

Hi Nitin,

There are team members actively working on cleaning up the model, but unfortunately it is not ready at this time.

However, as an alternative, there is a TINA-TI model and a PSPICE model that can be downloaded from the product folder.

Power management

Power management forum

Not able to simulate LM25118 using webench tool.