Lm5034 - current mode controller gate driver

anjali chugh

Other Parts Discussed in Thread: LM5034, LM5026

LM5034

High voltage dual interleaved current mode controller with active clamp , my requirement is to use only a single channel so how i should made connections with channel 2 , they have to be left unconnected or to be ground .

Kindly reply ASAP .

over 13 years ago

0 Paolo Reggio over 13 years ago

Intellectual 930 points

Hi Anjali.

I suggest you to look for differente solutions or you could have troubles with the internal overlap generator block...

It is made to mix signals coming from the two controller blocks, I don't know what could happen if one of them is generating "strange" signals...

Bye

Paolo

0 Terry Allinder over 13 years ago

TI__Expert 3545 points

Anjali,

If you do not need the second channel, I suggest you look at the LM5026, which is a single Current mode Active Clamp Controller.

Terry

Power management

Power management forum

Lm5034 - current mode controller gate driver