TPS65910 PWRON AND INT1

Jerry Siu

Other Parts Discussed in Thread: TPS65910

Hi,

Is TPS65910 PWRON signal low level dbPWRONF(500~550ms) will make INT1 active (IT_POL
=0 PWRON_IT_MSK=0) and INT1 will hold low until clear PWRON_IT bit by set 1?

over 12 years ago

0 Flore Auzanneau over 12 years ago

TI__Intellectual 1820 points

Hello,

INT1 will be active as long as interrupts have not been cleared.

Best regards,

Flore

0 Jerry Siu over 12 years ago in reply to Flore Auzanneau

Prodigy 130 points

Thanks for reply Flore.

I have another question. TPS65910 PWRON signal low level dbPWRONF(500~550ms) is that means I press PWRON down after about 0.5 sec would make INT1 active？

If so ,that means I can't used this signal for a power key to send a KEY_POWER keycode. It make a long time lag.

0 Jerry Siu over 12 years ago in reply to Jerry Siu

Prodigy 130 points

Is someone can help me with above problem

Power management

Power management forum

TPS65910 PWRON AND INT1