bq51013 shielding

Argail

Expert 2080 points

Other Parts Discussed in Thread: BQ51013

Hello,

I was wondering about designing a PCB coil and adding all bq51013 component on one PCB side. Wih this design there is no shielding between the coil itself and the bq51013 system. The transmitted power will be between 50 and 100mA.

Is there any feedback on this configuration?

over 12 years ago

0 Bill Johns over 12 years ago

TI__Guru* 75486 points

A PCB coil for a low power application is possible. But a shield behind the coil will probably be needed for good performance. Adding the RX circuit to the same PCB should not be a problem.

0 Argail over 12 years ago in reply to Bill Johns

Expert 2080 points

Thank you for your answer and time:)

0 Dinesh Kodiguti over 12 years ago in reply to Argail

Prodigy 10 points

Can you tell me what material is sheild of a coil is made of?

Power management

Power management forum

bq51013 shielding