Fusion Digital Power Design Tool Schematic error

Kim1115

Other Parts Discussed in Thread: UCD74120

When the GUI tool creates a schematic with a UCD74120 device it always shorts EAP and EAN together. I am guessing that this is not a real issue during simulation but is only a visible error in the display.

over 12 years ago

0 Carl Wu over 12 years ago

TI__Prodigy 180 points

Hi Kim,

I tried creating schematics by using UCD74120 but didn't find same issue as you described. There should be a resistor and a capacitor between EAP and EAN.

Would you please tell me which Fusion GUI version you used? And which controller did you choose?

Thank you.

0 Carl Wu over 12 years ago in reply to Carl Wu

TI__Prodigy 180 points

Hi Kim,

I reviewed the schematic again, found one dot was put on wrong place and made you confused.

We will correct this on next version Fusion GUI. This doesn't affect simulation, so you can continue using current version for design.

0 Kim1115 over 12 years ago in reply to Carl Wu

Prodigy 110 points

OK, thanks. I just finished creating example but you located issue first. BTW, I am using Rev 1-8-284

Power management

Power management forum

Fusion Digital Power Design Tool Schematic error