Pspice model for LMR10515 - How to use ?

Christophe Guillon

Other Parts Discussed in Thread: LMR10515, TINA-TI

Hello,

I would like simulate a power converter using a LMR10515. But the LMR10515 model provided in TI website does not work... Even with TINA-TI software. Is-it possible to have a model compatible with TINA-TI?

Thanks in advance,

Ch.

over 11 years ago

0 Tommy Jewell - WEBENCH Design Center over 11 years ago

TI__Intellectual 2930 points

Hi,

The stand-alone model provided for the LMR10515 must be used in PSpice, is this what you're using?

Best regards,
Tommy

0 Christophe Guillon over 11 years ago in reply to Tommy Jewell - WEBENCH Design Center

Prodigy 60 points

Hello Tommy,

No unfortunately , I have only LTspice and Simetrix at my job... So, I had thought try with TINA-TI...

Best regards,

Christophe.

0 Tommy Jewell - WEBENCH Design Center over 11 years ago in reply to Christophe Guillon

TI__Intellectual 2930 points

Hi Christophe,

Sadly that is the only format we currently have the stand alone model in. I can put in a request for the TINA-TI model to be created but this will take some time.

You can also do some basic simulation for this part in the online WEBENCH tool without downloading anything (assuming you have java and flash enabled in your browser):

http://webench.ti.com/webench5/power/webench5.cgi?VinMin=3.00&VinMax=5.50&O1V=1.80&O1I=1.50&base_pn=LMR10515Y&AppType=None&op_TA=30&lang_chosen=en_US&optfactor=3

Best regards,
Tommy

0 Christophe Guillon over 11 years ago in reply to Tommy Jewell - WEBENCH Design Center

Prodigy 60 points

Thank you Tommy for your answer.

Could you place the model in the TINA-TI creation loop?

Best regards,

Christophe.

0 Nikhil Gupta (Product Folder Models) over 11 years ago in reply to Christophe Guillon

TI__Mastermind 39210 points

Hi Christophe,

Which version are you looking for X or Y?

Thanks,

0 Christophe Guillon over 11 years ago in reply to Nikhil Gupta (Product Folder Models)

Prodigy 60 points

Hi,

I am looking for the X version.

Best regards,

Ch.

0 Nikhil Gupta (Product Folder Models) over 11 years ago in reply to Christophe Guillon

TI__Mastermind 39210 points

Hi Christophe,

The TINA-TI model for the X version was released to the product folder today. You should be able to access it after the next web update. Let me know if you have any questions.

Best regards,

Power management

Power management forum

Pspice model for LMR10515 - How to use ?