LP3943 Standby

Dan C

Hi,

Apologies if this is the wrong forum (not sure which category this part would fall under?)

My question is:

The datasheet quotes a 'standby' current for this part of 2uA. How do you enter standby mode? is it simply holding RST low?

Many thanks

over 11 years ago

0 Sami Kotijarvi over 11 years ago

TI__Intellectual 2510 points

Hi Dan,

Sorry for the delay in response.

This seems to be a bit older product, but what I found was that "Standby Mode( All Leds turn off) ;No Load; Vi= VDD or VSS; fSCL=0 kHz". Here I assume the Vi means the LED I/O.

Hopefully this helps you.

Best regards,

Sami

Power management

Power management forum

LP3943 Standby