TPS65910A - DC load regulation and DC line regulation

Hi Hirotaka, What it means is the if the voltage is programmed 1.5v than load regulations is x% then according to the datasheet test condition any change in the load from one point to other can cause a voltage to change b/w +- X % of 1.5v.

Hope this helps!

Hi Puneet San,

We appologize that we can not understand your updata and your grammer.
So, in order to clear to your reply, may I ask some questions?

<Question1>
What does it mean "one point to other"?

<Question2>
What does it mean "any change in the load" means?
→It means that there is no change in the load or not?

We need much your help.

Kind regards,

Hirotaka Matsumoto

1.  I mean to say if load changes : for example lets say it changed from 100ma to 900mA.

2.  It means if there is change in load.

Hope this helps!

Hi Puneet San,

Thank you for your reply.
However, we understand it.

To fit both consensus, we sent the file whch we request.
Please refert to attached file which shows line regulation and load regulation on TPS736XX.
So, we need information as like them.
4848.For example.pdf

Kind regards,

Hirotaka Matsumoto

Puneet San,

OK, we got your saying!
As you mentioned, we're sorry that this was simple caluculation.

Kind regards,

Hirotaka Matsumoto