UCC28950 Burst Mode

mark prosser

Other Parts Discussed in Thread: UCC28950

Hello All,

Regarding the Tmin setting for burst operation of device UCC28950 , I know that 13k is recommended minimum but please can anyone advise if there is a restriction on the maximum value?

over 10 years ago

0 John Griffin1 over 10 years ago

TI__Mastermind 34465 points

The value of resistor RTMIN is shown calculated in equation 140 of document

http://www.ti.com/lit/an/slua560c/slua560c.pdf

TMIN is the minimum pulse width required and its value is going to be less than the normal operating pulse width.

So the this sets an upper limit on the value of TMIN

Power management

Power management forum

UCC28950 Burst Mode