• State
  • Locked Locked
  • Replies 4 replies
  • Subscribers 62 subscribers
  • Views 636 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Inquiry regarding maximum output current on UCC27325

Atsushi Okui
Genius 4015 points
Other Parts Discussed in Thread: UCC27325

Hello, all

Now we have one inquiry regarding maximum output current on UCC27325 from our customer.

Please refer to the item below, and feedback us with your comment.

When referring ABSOLUTE MAXIMUM RATINGS on datasheet page 3, the Maximum Output current (OUTA, OUTB) is defined as 4.5A on Pulsed (0.5 μs).

However, we could not find out any other information on the datasheet. 

We would appreciate if you could disclose some characteristics (we would prefer graph) which describes output current vs pulse.

We thank you in advance for your information.

Best regards,

  • 0
    TI__Mastermind 31580 points
    Hi,

    Unfortunately we do not have this information available, the peak currrent rating is provided to give some guidance to the performance when charging the gate capacitance of a Mosfet as it transitions through the miller region.

    Regards

    Peter
  • 0 in reply to Peter Meaney
    Genius 4015 points

    Hello, thank you for your reply.

    With regard to this device, please let us clarify whether this could handle the following load or not.

    VOUTA=15.0V IOUTA=2.0A and VOUTB=15.0V IOUTB=2.0A at sametime

    Switching Frequency for all internal MOSFET is 1kHz

    We thank you once again for your information.

    Best regards,

     

  • 0 in reply to Atsushi Okui
    Genius 4015 points

    Hello, 

    With regard to the additional inquiry above, we have actual scope of output voltage and current per one cycle.

    This continues every cycle on 1kHz switching.

    Please let us clarify whether this acceptable for this device.

    We thank you once again for your information.

    Best regards,

  • 0 in reply to Atsushi Okui
    TI__Mastermind 31580 points
    Hi Atsushi-san,

    The device is capable of 4A peak and the waveform is 3.4A so that is ok. The other aspect is that the switching frequency is low at 1kHz so the thermal stress should be low as well, but we should advise the customer to check the driver IC case temperature under worst case conditions as a precaution.

    Regards

    Peter