Hi,
I am designing Wireless power charger transmitter using BQ500414Q. Can you help for following question
1) what is minimum and maximum distance between Tx and Rx coil.
2) What are all the object acceptable in between Tx and Rx coil, like conductive and non-conductive material.
3) In my project distance between Tx and Rx coil is 10mm, it is acceptable or not.
4) In my project PCB exist between Tx and Rx coil, it is acceptable or not.
5) How to tune PMOD and FOD
6) Can we decide the how much power to be transmitted from TX to RX or is it depends on only messages received by receiver.
