UC2625 typical application

Savas PINAR

Other Parts Discussed in Thread: UC2625-EP

hi everyone,

I am drawing a schematic by using UC2625EP typical application circuit in datasheet, but there is no BoM in its datasheet about component properties. Normally, there is a BoM in IC datasheets. Where can I find properties of components. Thanks for any helps in advance.

over 9 years ago

0 Peter Meaney over 9 years ago

TI__Mastermind 31580 points

Hi

Try this applications note, www.ti.com/lit/ds/symlink/uc2625-ep.pdf

It contains a schematic with component values.

Regards

Peter

0 Savas PINAR over 9 years ago in reply to Peter Meaney

Intellectual 270 points

thanks peter,
I have an another question. Do I have to use BLDC motor with hall effect sensors? Does the design work if I use sensorless BLDC?

0 Savas PINAR over 9 years ago in reply to Savas PINAR

Intellectual 270 points

Besides, I have BLDC sensorless motor. Its specs are 890 rpm/V, 1380 watt peak power, 1080 watt max continuous power, no load current 1.2-1.7 A. Max continuous current 48 A. In my project I will use 15.6 Volt battery and I want to reach 700-800 watt power. Can you suggest which control method and driver IC is the best for this solution? thanks in advance for your help

regards

Savas

0 Peter Meaney over 9 years ago in reply to Savas PINAR

TI__Mastermind 31580 points

Hi Savas,

When you mention control method and driver IC, is this for the power supply or for the motor control?

I have no experience in motor drive, my experience is in power supply circuits.

Regards

Peter

0 Savas PINAR over 9 years ago in reply to Peter Meaney

Intellectual 270 points

for motor control. thanks for response
Regards
Savas

Power management

Power management forum

UC2625 typical application