Power management

Power management forum

State
Locked Locked
Replies 3 replies
Subscribers 62 subscribers
Views 415 views
Users 0 members are here

Support feedback

Options

Options

Related

Unused FLT pin in TPS25910

Juan Medrano83

Intellectual 535 points

Other Parts Discussed in Thread: TPS25910

Hi everyone,

I am using a TPS25910 in one application. At the beginning we were going to implement the FLT pin information, but now we are not going to do it. The question is: if I am not using this pin, should I leave it floating or should I connect it to a specific node (ground?)?

Thanks TI and forum members!

Juan

over 10 years ago

0 Dinesh Kumar6 over 10 years ago

TI__Intellectual 2980 points

Hello Juan,

in that case, you can pull up /FLT pin to Vout.

Regards

Dinesh

0 Dinesh Kumar6 over 9 years ago in reply to Dinesh Kumar6

TI__Intellectual 2980 points

Hello Juan,

I apologies, for my earlier comment , actually /FLT pin should be left floating.

Please remove the pull up resistor if you used.

Regards

Dinesh

0 Juan Medrano83 over 9 years ago in reply to Dinesh Kumar6

Intellectual 535 points

haha Thanks Dinesh, yes actually I thought the last suggestion was not very accurate :)

Thanks for the confirmation.

Juan