bq24167 Charge status

PAN-M

Dear all.

Our customer made 25's ES boards.
Only one board, even if there are no battery, it will be during charge state.

1) No battery
2) BAT=4.2V and CHG=Low (pull up)
3) No charge detection phase (Charge detection phase works for other 24 boards)

Would you please give me any comment.

Regards,
PAN-M

over 9 years ago

0 Jeff F over 9 years ago

TI__Guru**** 152776 points

Are you saying that battery detection is not working, i.e., there is no square-ish waveform on BAT? If so, is input current limit 100mA, during which termination and battery detection is disabled?

0 PAN-M over 9 years ago in reply to Jeff F

Mastermind 8375 points

Yes, battery detection is not working.
When input current limit is 100mA, does battery detection become invalid?

0 Jeff F over 9 years ago in reply to PAN-M

TI__Guru**** 152776 points

Yes, battery detection is disabled if input current limit is set to 100mA.

0 PAN-M over 9 years ago in reply to Jeff F

Mastermind 8375 points

Thank you.
I will check customer board.

0 PAN-M over 8 years ago in reply to PAN-M

Mastermind 8375 points

Our customer said power supply is only IN. (USB1-3 are pull down)
Still is it affected?
Regards,
PAN-M

0 PAN-M over 8 years ago in reply to PAN-M

Mastermind 8375 points

Jeff-san
If IN and USB shorted, doesn't Battery Detection do?
Regards,
PAN-M

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Power management

Power management forum

bq24167 Charge status