• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 63 subscribers
  • Views 629 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UCD9222 & UCD9244 Power Program

Rajesh KP
Prodigy 80 points
Other Parts Discussed in Thread: UCD9222, UCD9244

I am using UCD9222 & UCD9244 for my module i have programmed with my file.Actually  i need to change the power output file with another configuration.

My question is can i  reprogram the Power controller with another file is it possible.

  • 0
    TI__Genius 9845 points
    Yes. You can re-configure the device using Fusion Digital Power Designer GUI, which can be downloaded from TI website.

    You will need a USB-to-GPIO adapter (sold separately). You should also have a 5x2 PMBus connector on the board to hook up the adapter.

    Regards,
    Zhiyuan